Step -1

Step -2

Step -3

Place the sink in upside down position. Then attach clips into rectangular slots of the rim along the border, as shown in the sketch.

Refer the sketch & make cut out in the Tabletop 10 MM less from each side than the outer size of sink. Make the step as shown in figure for flushing the sink border with Tabletop (If flushing isrequired)

Step -4

Turn the bracket of the clip 90 degrees so that the teeth of clips are under the tabletop. First tighten the center clips of each roil and then move to the outside clips. All clips must be tightened evenly. Do not over tighten the clips as damage can result.